Home / Service areas /Toronto / Tankless Water Heater
Tankless Water Heater · Toronto, OntarioTankless Water Heater Installation in Toronto
Tankless water heater installation in Toronto costs $3,500–$6,500, and the most common job, a 199,000 BTU Navien or Rinnai replacing a tank, lands at $4,200–$5,000 installed. On the narrow lots of the west side two things move the price: where the vent can legally exit, and whether the gas line can feed the unit, with upsizing adding $400–$1,200. Both are settled at the quote visit and written down before you commit.
Fitting a tankless water heater into a Toronto semi or row house
A tankless unit suits Toronto's older houses for a plain reason: space. The basement of a Victorian or Edwardian semi is often a dug-out room with low headroom, and a 40-gallon tank beside the chimney takes floor that a wall-hung unit the size of a carry-on bag gives back. The trade-off is distance. Hot water from a unit at the back of the basement takes a while to reach a third-floor bathroom, so in a tall house we talk about pipe routing or a recirculation loop at the quote, not after the first slow shower.
Venting is the hard part on these lots. A condensing tankless unit exhausts through plastic pipe, and CSA B149.1 and the manufacturer set how far the termination must be from windows, doors, gas regulators and air intakes. A semi has one open side, usually a narrow shared passage, and a row house has none, so the realistic exits are the rear wall or the roof, sometimes by running the pipe up the old chimney flue. Each route has a maximum length, and we measure it before recommending a model.
Gas is the other half. The meter on these houses is usually at the front, the water heater sits mid-house by the chimney, and the tank was fed by a small branch teed off the furnace line. A 199,000 BTU unit needs a correctly sized run of its own from near the meter, which in a finished basement means working along the joists or opening a ceiling. That is the $400–$1,200 line on the quote, and if the total load exceeds what the meter can deliver, Enbridge Gas has to change the meter, which we flag before you sign.
If the house heats with a boiler and radiators, look at a combi boiler before buying a tankless unit, because one appliance can do both jobs; combi boiler vs boiler and water heater compares them. Toronto's water is moderately hard, so plan on a descale flush each year at $150–$300, and remember the unit needs 120-volt power and will not fire during a Toronto Hydro outage. The tankless cost guide itemizes the whole job, water heater service in Toronto covers tank repairs and swaps, and the tankless water heater page explains the install day. For other work in the city see the Toronto service area page, or ask for a written quote.
Why ZK Mechanical for tankless water heater in Toronto
- Vent exits planned for semis and row houses: rear wall, roof or the old chimney flue, measured against the unit's limits
- Gas line sized from the meter for 199,000 BTU, with the upsizing cost shown as its own line
- Wall-hung units placed to free floor space in low dug-out basements
- Recirculation options explained for three-storey houses where the top bathroom is a long pipe run away
- Combi boilers quoted alongside tankless for houses heated by radiators
- Navien, Rinnai and Bosch units, installed by TSSA-licensed gas technicians
- Condensate drain and 120-volt supply written into the scope, not added later
Licensed technicians, Toronto dispatch, no overtime charges.
Tankless Water Heater in Toronto — FAQs
How much does tankless water heater installation cost in Toronto?
Three figures cover most houses. The full installed range is $3,500–$6,500. The common conversion, a mid-tier 199,000 BTU gas unit in place of a tank, is $4,200–$5,000. Upsizing the gas line, when the old pipe is too small, adds $400–$1,200. A vent run through the roof or a relocated unit sits toward the top of the range, and the written quote shows which parts of the job put it there.
Can a tankless water heater be vented in a row house with no side walls?
Yes, through the rear wall or the roof. A rear-wall termination needs clearance from the back door, windows and any deck above it. A roof termination runs the pipe vertically, often inside the unused chimney flue, and suits a unit mounted near that chimney. What will not work is a pipe poked into a shared passage where the clearances cannot be met; an inspector will fail it and the exhaust will bother the neighbour.
Will one unit supply a three-storey house with two bathrooms?
In most cases. A 199,000 BTU unit is sized to run two showers at once on winter-cold inlet water, which covers a typical two-bathroom house. Three bathrooms in use together, a large soaker tub, or a basement apartment on the same supply may call for a larger unit or a second one. We count fixtures and ask how the household uses hot water before choosing, and put the reasoning in the quote.
My tank is a rental. Can I still switch to tankless?
Yes. Ask the rental company for the buyout figure and the return procedure in writing, then decide whether to buy the tank out or send it back. Renting runs $25–$45 a month and rises yearly, so over 15 years it comes to $4,500–$8,000. We disconnect the tank on install day so it can go back, and you keep the paperwork that closes the account.
What maintenance does a tankless unit need in Toronto?
One visit a year. The technician circulates a descaling solution through the heat exchanger, cleans the inlet water filter, checks the condensate drain and inspects the vent and burner. It costs $150–$300. Skipping it lets scale insulate the heat exchanger, and the first signs are water that swings hot and cold or an error code on the display. Isolation valves installed with the unit make the flush a short job.
Other HVAC services in Toronto
Tankless Water Heater in Toronto — fast.
Emergency repair or planned upgrade, quoted in writing before any work starts.